電池須自備

1、可以對拷的晶片：

2260（所有廠商）、2262（所有廠商）、PT2264、5326（所有廠商）、SC5262、HT600、HT680、HT6207、HT6010、HT6012、HT6014、SMC918系列、527（所有廠商）、1527（所有廠商）、2240（所有廠商）、HCS101、HCS200＼HCS201(部分代碼）、HCS300＼HCS301(部分代碼）、部分單片機..........

1.Chips could be copied

2260(all manufacturers);2262(All manufacturers);PT2264, 5326(All manufacturers);SC5262, HT600, HT680, HT6207, HT6010, HT6012, HT6014, SMC918series,527(All manufacturers);1527(All manufacturers);2240(All manufacturers);HCS101, HCS200＼HCS201(part code),HCS300＼HCS301(部分代碼), part single chip microcomputer..........

2、清碼方法：

同時按住開鎖與關鎖兩鍵（有些外殼是上行與下行兩鍵），LED指示燈閃爍三下，鬆開按下去的任意一個按鍵，另一個不松，點擊鬆開的按鍵三下，LED指示燈進入快速閃爍狀態，此時記憶體的資料全部清除，清完資料之後的遙控器，無論按哪個按鍵，LED指示燈都是不亮。

2.Code cleaning method:

Press the unlock button and lock button at the same time(some shells are the up button and down button), after the LED indicator light flashes three times, loosen any one of the buttons while the other is kept pressing, then push the released button three times, the LED indicator will enter into the fast flashing status. At this time all the memory data is cleared, the cleaned remote control will not have lighting LED indicator no matter which button you press.

3、對拷方法：

一手持原配遙控器，另一手持對拷遙控器，兩隻遙控器儘量靠近，(理想的是將兩個遙控器零距離邊靠著邊放在桌面上)分別按下所需對拷的按鍵，LED指示燈快速閃爍三下之後快速閃爍，對拷成功，其他按鍵操作方法相同。有些遙控器發射功率較小，應原配遙控器與對拷遙控器背靠背操作，才好對拷。有些操作環境有干擾的，應避開干擾操作，如果對拷不太好使的，清碼以後重新對拷。（特別重要：您手上的遙控器必須能正常工作且與我們的遙控器頻率相同）

1. 3. Copy method

One hand keeps the original remote controller, while another keeps the copy remote control, the two remote controls should be placed as closely as possible (the ideal situation is to put the two remote controls on the desktop side by side with zero distance), respectively press down the copy button, when the LED indicator light flashes quickly after three flashes, this copy is successful, other key operating methods are the same. Some remote control has a smaller transmitting power, so the original remote control should be placed back to the copy remote control to be operated. For the presence of noise, it should avoid interference to operate, If the copy is not successful, it should recopy after clearing code.（ Attention：Your original remote control must be able to work and the same as our remote control frequency）

4、新款對拷遙控器特點：

1. 4. The features of new copy remote control

The four buttons could respectively copy four different types of chips, That is a remote control can operate four different types of facilities. The frequency is from 270MHz to 434MHZ and more than ten frequency points. Faster copy data speed, not easy losing code, far distance.

📣尺寸因人手測量, 會有些許釐米偏差, 一切以實物為準。

📣網頁圖片因拍攝關係會與實際商品略有色差，圖片僅供參考，顏色請以實際收到之商品為準。

【宅配及超商】

🚚黑貓與賣家宅配及店取，寄出後，約1-2天到貨。

⚠收到產品時發現產品異常，請拍商品照片和出貨單，傳至聊聊，上班時間會馬上為您處理。

📋如遇商品體積過大無法超取，需請買家配合更改寄送方式。

【客服諮詢】

✔歡迎使用問與答，有專人在線為您服務。

🙏問與答回應若有怠慢，請您稍微等待，請勿用評價作溝通管道哦!🙏

🔥商品持續上新，歡迎追蹤 +關注!

💯喜歡我們商品與服務，歡迎給我們滿滿★★★★★顆星哦!💯

☎ 客服時間 :週一至週五 09:00~18:00 ( 國定假日休息 )